We use kraft paper and polystyrene.

To remove the paper, you will first need to get it slightly wet. A spray bottle works best, but you may also use a sponge. Allow the paper to absorb the water. Peel the paper while it is still damp but not tearing away in small pieces.

If there are any small stubborn areas, you can gently rub the surface to remove the paper.

Yes! Make sure you follow all safety precautions. Ensure you have adequate ventilation, preferably with a fume extraction system. Wear safety glasses and heat-resistant gloves. Always supervise the entire process.

Our paper is acid neutral. We have mounted inkjet prints, laser prints and fabric with no issues.

Yes. If untreated, environmental factors (such as the sun, wind and rain) will damage the foam board.

There are effective methods to protect and make your board water-resistant. Feel free to use the Readi-Board Blog contact form, tell us about your project, and we can make recommendations.

The best tool is one you feel comfortable and SAFE with. We recommend a hobby knife, or utility knife. The most important thing is to make sure you are always using a sharp blade. You will likely have to change your blades much more frequently than expected.

If the paper is tearing, or the foam is bunching/pilling, that is a good sign you need a new, sharp blade.

This usually happens because the paper on one side of the board has gotten damp (either from paint or glue). As the paper dries it shrinks slightly, causing the board to warp or curl.

To correct this, you can dampen the opposite side. Either with water in a spray bottle, using a damp cloth, or painting with the same or similar paint used originally.

You can also set the board on a flat surface and use some heavy objects to press down the board as it dries. Old books work great for this.